Honda Civic Service Manual page 1335

Door and Side Moldings
Replacement
CAUTION: When prying with a flat-tip scr6wdrivgr, wrap it with protective tape to
prevent damags'
NOTE;
. To remove the front side molding, remove the inner fender (see page 20-106)'
. To remove the door moiding, remove the door panel (see pages 20-4, 10, 16) and plastic cover.
. To removethe rearside molding, remove the side trim panel (see pages 20-60,611'
. Take care not to bend the door moldings.
. Before reassembling, clean the door bonding surface with a sponge dampened in alcohol'
. After cleaning, keep oil, grease and water from getting on the surface'
.
lf necessary, replace any damaged clips.
4D:
FRONT DOOR
Adhesive areas.
2Dl3Dl
B > , 3
c > , 2
REAR SIDE
MOLOING
a: Plastic nut loc€tion. 1
@)
(cont'dl
2 0 - 1 0 3
MOLDING
>: Clip locations
A >: 4D, 11
2')13D,7