Honda Civic Service Manual page 1167

)
lO. Apply grease to the points indicated by the arrows
in the following illustration:
NOTE: Use the pad grease included in the pad set
or Molykote M77 grease, and apply a thin coat of
grease evenly to the designated points.
. Piston end and inner pad contact surface
o Pad and caliper bracket contact surface
. Outer pad and caliper body contact surface
. Outer pad shim and outer pad contact surface
. Outer pad shim and caliper body contact surface
OUTER PAD
OUIER
PAD SHIM
I 1. Install the brake pads and pad shim correctly
@
o When reusing the pads, always reinstall the
brake pads in their original positions to plevent
loss of braking etticiencY.
. Contaminated brake discs ol pads reduce stop-
ping ability. Keep grease oft the discs and pads.
N O T E : I n s t a l l t h e p a d w i t h t h e w e a r i n d i c a t o r o n
the inside.
WEAR INDICATOR
12. Push in the piston so that the caliper will fit over the
pads. Make sure that the piston boot is in position
t o p r e v e n t d a m a g i n g i t w h e n p i v o t i n g t h e c a l i p e r
CALIPER BOLT B
26 N.m {2.7 kgt m,
20 rbl.ftl
1 4 .
1 3 . P i v o t t h e c a l i p e r d o w n i n t o p o s i t i o n , t h e n i n s t a l l
caliper bolt B and tighten it.
lnstallthe brake hose bracket on the knuckle.
NOTE: Inspect the brake hose for interference and
twisting.
Depress the brake pedal several times to make sure
the brakes work, then test-drive
N O T E : E n g a g e m e n t o f t h e b r a k e m a y r e q u i r e a
greater pedal stroke immediately after the brake
pads have been replaced as a set. Several applica-
t i o n s o t t h e b r a k e p e d a l w i l l r e s t o r e t h e n o r m a l
pedal stroke.
After installation, check for leaks at hose and line
joints and connections, and retighten if necessary.
1 6 .
PISTON
1 9 - 1 1