Honda Civic Service Manual page 1468

Compressor (DENSO)
Clutch Overhaul (cont'd)
Remove the screw from the field coil ground termi-
nal. Remove the snap ring A with snap ring pliers.
then remove the field coil. Be careful not to damaoe
the field coil and compressor.
SNAP NING A
Replace.
Reassemble the compressor clutch in the reverse
order of disassembly, and note these rrems:
o I n s t a l l t h e f i e l d c o i l w i t h t h e w i r e s i d e f a c i n g
down.
a Clean the pulley and compressor sliding surfaces
with non-petroleum solvent.
. Install new snap rings, and make sure thev are
fully seated in the groove.
. Make sure that the pulley turns smoothly after
it's reassembled.
. Route and clamp the wires p.operly or they can
be damaged by pulley.
FIELO
corL
22-42
13.2 N.m 11.35 kgt m,9.76lbtttl
Relief Valve Replacement
L
4 .
Recover the refrigerant with a recovery/recycling/
charging station {see page 22-27),
Remove the relief valve and the O-ring. plug the
opening to keep foreign matter from entering the
system and the compressor oilfrom running out.
Clean the mating surfaces.
Replace the O-ring with a new one at the relief valve.
and apply a thin coat of refrigerant oil before install-
ing it.
Remove the plug, and install and tighten the relief
vatve.
Charge the system (see page 22-46), and test its per-
formance (see page 22-24),