NOTE: Place the clutch housing on two pieces of wood
t h i c k e n o u g h t o k e e p t h e m a i n s h a f t f r o m h i t t i n g t h e
1. Remove the back-up light switch.
Remove transmission hanger.
BACK-UP LIGHT SWITCH
Remove the setting screws. washers. springs, and
O . 5 / 1 6 i n
L . 3 1 . 6 m m I 1 . 2 4 i n l
1 3 -1 2
Loosen the transmission housing attaching bolts in
a crisscross pattern in several steps, then remove
t h e m .
Remove the 32 mm sealing bolt.
Expand the snap ring on the countershaft ball bear-
ing, and remove it from the groove using a pair of
snap ring pliers.
32 mm SEALING EOLT
Separate the transmission housing from the clutch
housing, and wipe it clean of the sealant.
Remove the thrust shim, oil guide plate. and oil gut-
ter plate from the transmission housing.