Honda Civic Service Manual page 1212

L
J
DTG Erasure
1 .
2 .
Connect the SCS service connector to the service check connector inside the passenger's side kick
panel.
Depress the brake pedal.
Turn the ignition switch oN (ll) while holding the brake pedal, but do not start the engine. The ABS
indicator light
goes off after two seconds.
After the indicator light goes off, release the brake pedal The indicator lightcomeson after four seconds
After the indicator light comes on, depress the brake pedal again. The indicator light
goes off again after four sec-
onds. The brake pedal is still depressed.
4 .
5.
\
t
6.
After the jndicator light goes off, release the brake pedal again'
7.
After four seconds, the indicator light blinks twice for 0 3 second and the DTC is erased
8.
Confirm the DTC indication, and check that the DTC was erased
NOTE: Always maintain these steps. lf you disconnect the scs service connector and/or fail to operate
the brake pedal
according to the indicator light indication, the DTC will not be erased
Conditions for DTC erasure
o The vehicle is stopped.
. The SCS service connector is connected before the ignition switch is turned ON {ll)
. The brake pedal is depressed before the ignition switch is turned ON (ll)'
. The SCS service connector remains connected during this procedure
The DTC erasure stops and ABS control unit executes the software lunction it at least one ot the
following conditions is
satisfied:
o The vehicle is not stopped.
. The SCS service connector is disconnected during this servace'
. T h e A B s c o n t r o | u n i t r e c e i v e s t h e n o r m a I s i g n a | ( w h i c h i s f o r t h e A E s c o n t r o | u n i t ) f r o m a H o n d a P G M T e s t e r '
. The brake pedal is not operated according to the indicator light indication
. The DTC erasure is finished
ABS INDICATOR LIGHT
OFF
D E P R E S S
BRAKE PEDAL
RELEASE
0 . 3 s e c
lqnition switch
o N ( I )
J
19-57