Honda Civic Service Manual page 1032

1996-2000
Hide thumbs Also See for Civic:
Table of Contents

Advertisement

t
Adjustment
!@
Make sure lifts, jacks and safety stands are
placed properly (see section 1).
l.
Remove the front console (see section 20).
2.
Shift to I
posirion, then remove the lock pin from
the adjuster.
SHIFT CAELE
l ,
,l
{ 0 . 7 k g f . m , 5 l b f ' l t l
3. Check that the hole in the adiuster is perfectly aligned
with the hole in the shift cable. There are two holes in
the adjuster. They are positioned 90" apart to allow
cable adjustment in 1/4 turn increments.
lf the hole is not perfectly aligned, loosen the lock-
nut on the adjuster and adjust as required.
Tighten rhe locknut to 7 N.m (0.7 kgim,5 lbf'ft).
Install the lock pin on the adjuster' lf you feel the
lock pin binding as you reinstall it. the cable is still
out of adjustment and must be readjusted
M a k e s u r e t h e l o c k p i n i s s e a t e d i n t h e a d i u s t e r
securery.
lMove the shift lever to each position, and verify that
t h e s h i f t p o s i t i o n i n d i c a t o r f o l l o w s t h e a u t o m a t l c
transaxle gear position switch.
S t a r t t h e e n g i n e , a n d c h e c k t h e s h i f t l e v e r i n a l l
positions. lf any gear does not work properly, refer
to troubleshooting (see page 14-294 and 14-295).
Insert the ignition key into the key cylinder on the
Aff gear position indicator panel, and verify that the
shift lock lever is released.
7 .
1 0 .
1 4 - 3 5 5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents