Honda Civic Service Manual page 1332

Trunk Lid/Hatch
Weatherstrip
License Plate Trim
Replacement
When installing the trunk lid/hatch weatherstrip. align it
with the alignment mark on the trunk lid/hatch opening.
NOTE:
. Make sure there are no wrinkles in the weatherstrip.
. Check for water leaks.
2DllDi
STEEI.
CORE
3D:
ALIGNMENT
MARK (2Dl4D)
ALIGNMENT MARK
WEATHERSTRIP
ALIGNMENT MARK
BODY
2 0 - 1 0 0
Replacement
CAUTION: Put on glov€s to plotest your hands.
NOTE: Take care not to scratch the trunk lid/hatch.
1. Remove the license plate.
2,
3D: Remove the hatch trim panel (see page 20-63).
3. Remove the nuts and clips, and detach the clip, then
remove the license plate trim.
NOTE: Take care not to drop the nuts inside the trunk
lid/hatch.
a: Nut locations,2
6 f i \ 5 x 0 . 8 m m I
rvr?// 1,8 N.m {0.18 kst.m,l
-
j llrftl
,/
>: Clip locations,
I
n A
aa# )
- , /
Installation is the reverse of the removal orocedure.
NOTE: lf necessary, replace any damaged clips.