Honda Civic Service Manual page 1150

Rear Suspension
Hub Bearing Unit Replacement (cont'dl
NOTE: Disc type {'99 2D Si and Si-R modets)
1. Loosen the wheel nuts slightly.
2. Raise the rear of vehicle, and support it with safety
stands in the proper locations {see section 1).
3. Remove the wheel nuts and rear wheel.
4.
Pull the parking brake lever up.
5 . R e m o v e t h e h u b c a p .
6 . R a i s e t h e l o c k i n g t a b o n t h e s p i n d l e n u t , t h e n
remove the nut. SPINDLE NUT
22 x 1.5 mrn
181 N.m (18.5 kgf'm, 134lbf.fi)
Replace.
NOT€:
. Eefore installing the spindle nut,
apply engine oil to the seating
surface of the nut.
. After tightening, use a drift to
stake the spindle nut shoulder
against the spindle.
lFor vehictes
\
\with drum brakes;/
WHEEL NUT
12 x 1.5 mm
108 N.m
I I 1 kgt m, 80 lbf.ftl
HUB CAP
Replace-
NOTE: Take care not to damage the hub untt
on disassembly.
Remove the 6 mm brake disc retaining screws.
7 .
6 mm BRAKE DISC
RETAINING SCBEWS
9.8 N.m 11.0 kgl.m, 7 lbf.frl
1 A - 2 4
8 .
9 .
Release the parking brake lever.
R e m o v e t h e b r a k e d r u m , h u b u n i t b e a r i n g , a n d
spindle washer lfor vehicles with drum brakes).
BRAKE DRUM
SPINDI-E WASHER
10. Remove the 6 mm flange bolts and caliper shield.
CALIPER SHIELO
C h e c k f o r b e n d i n g a n d d a m a g e .
6 mm FLANGE BOLTS
9.8 N.m {1.0 kgf.m, 7 lbf,ft)