Reassembly - Honda Civic Service Manual

Power Steering Pump
Reassembly
1 . Align the pin of the sub-valve with the oil passage
in pump housing. and push down the sub-valve.
Installthe snap ring properly.
OIL PASSAGE
Align the pin of
the oil passage.
PUMP HOUSING
SNAP RING
Install the new pump seal in the pump housing by
hand, then installthe pump seal spacer.
NOTE: Insert the pump seal with its grooved side
facing in.
Position the pump drive shaft in the pump housing,
then drive it in using a special tool as shown.
Install the 40 mm circlip with its radiused side fac-
ing out,
ATTACHMENT, 30 mm
BALL BEARING
40 mm CIRCLIP
d
gf'uMP
oRrvE sHAFr
/ffi\
f.\'vj
H
PUMP SEAL SPACER
n , /
/:K
/ZA\.--
PUMP SEAL
V
Reptace.
17 -44
ROLl.ERS
Coat the pump cover seal and the cover bushing
with the power steering fluid, then install the pump
cover seal into the groove in the pump cover.
lnstall the outer side olate over the two rollers.
ROL1IR
OUTER SIDE PLATE
4.5 mm ROLLER
5 mm ROLLER
PUMP COVER
BUSHING
Set the pump cam ring over the two rollers with the
" o " mark on the cam ring upward.
7 .
ROI,IIR SET HO'"ES
PUMP CAM RING