Honda Civic Service Manual page 798

Pressure Testing
@
I
While testing, be caroful of th€ rotating front wheels.
. Make sure lifts, iacks, and satoty stands are placod properly (see section 1)'
CAUTION:
. Beforo iesting, be sure the transmission fluid is tilled to tho proper level'
. Warm up tho engine before testing'
1. Raise the vehicle (see section 1).
2.
Warm up the engine, then stop the engine and connect a tachometer'
3.
Connect the oil pressure gauges to each inspection hole.
TOROUE: 18 N.m (1.8 kgf'm, 13 lbnft)
cAUTloN: connact the oil pressuro gauges securely; be suro not to allow dust and other foreign Parlicles
to entel
the inspestion holos'
A/T OIL PRESSURE GAUGE
SET w/PANEL
07t06 - 0020400
A/T LOW PRESSURE GAUGE
SET WPANEL
07406 - 0070300
A/T OIL PRESSURE HOSE
ADAPTER
07Mru - PY0120
(4 requiJedl
A/T OIL PBESSURE HOSE
2210 mm
OTMAJ - PY4{)llA
14 roquircdl
Start the engine, and measure the respective ptessure as follows'
a Line Pressure
. 1st Clutch Pressure
. 2nd,3rd and 4th Clutch Pressure
Install a new washer and the sealing bolt in the inspection hole. and tighten to the specified torque'
TOROUE: l8 N.m (1.8 kgf'm,13lbf'ft)
NOTE: Do not reuse old sealing washers; always replace washers'
(cont'd)
14-119