Honda Civic Service Manual page 1099

Disassembly
CAUTION: The power steering components are made of aluminum. Avoid damaging the components during assembly.
NOTE:
. Ctean the disassembled parts with a solvent, and dry them with compressed air. Do not dip the rubber parts in a sol-
vent.
. Alwavs replace the O-rings and rubber seals with new ones before assembly.
. Apply recommended power steering fluid to the parts indicated in the assembly procedures'
. Do not allow dust, dirt, or other foreign materials to enter the power steering system.
. Replace the pump as an assembly ifthe parts indicated with asterisk (*) are worn or damaged'
FLANGE BOLTS
20 N.m {2.0 kgf.m,
14 rbf ft)
5 mm ROLLER
4.5 mm ROLLER
*OUTER SIOE PLATE
*SUB-VALVE
.PUMP NOTOR
}SIDE PLATE
l , /
SNAP RING
13 x 1.9 mm O-RING
Replace.
15.2 x 2.4 mm O-RING
Replace.
INLET JOINT
51 x 2.4 mm O-RING
Replace.
FLANGE BOLTS
11 N m 11.1 kgf.m,
8 rbf.ftl
PUMP SEAL
Replace.
PUMP SEAL SPAC€R
.PUMP DRIVE SHAFT
BALL BEARING
lnspection and RePlacement,
see page 17-43
10 mm CIRCLIP
*FLOW CONTROI- VALVE
Inspection and Overhaul,
se[ pase tt.tz
g
4 --{;'rX!;'
seatuc/
$
mm O-RING
PULLEY NUT
6il N.m {6.5 kgf.m,
47 tbf.frl
FI-OW CONTROL VALV€ CAP
49 N.m {5.0 kgt m,
36 rb{.ft)
(cont'd)
17-41
J