Honda Civic Service Manual page 1194

Rear Drum Brake
Brake Shoe Reassembly {cont'dl
C o n n e c t t h e p a r k i n g b r a k e c a b l e t o t h e p a r k i n g
brake lever.
Apply grease on each sliding surface.
!@
contaminated brake linings reduce
stopping ability. Keep grease or oil off the blake lin-
ings. Wipe any excess grease off the parts,
. Apply brake cylinder grease {P/N: 08733 - 8020E)
o r e q u i v a l e n t r u b b e r g r e a s e t o t h e s l i d i n g s u r -
faces as shown.
+a
Sliding surlace
Apply Molykote 44MA to the brake shoe ends and
opposite edges ofthe shoes as shown.
_' o
Opposite edge of the shoe
+ O
B r a k e s h o e e n d s
1 9 - 3 8
1 3 .
5. Clean the threaded portions of clevises A and B.
Coat the threads of the clevises with grease. To
shoften the clevises, tun the adjuster bolt.
6. Hook the self-adjuster spring to the self-adjuster
lever first, then to the brake shoe
7. Install the clevises and upper return spring. noting
the installation direction.
NOTE: Be careful not to damage the wheel cylinder
dust covers,
8. Install the lower return spring.
9. Install the tension pins and retaining springs.
uppER RETURT{ SpRtNG
CLEVIS B
CLEVIS A
Installthe brake drum.
lf the wheel cylinder has been removed, bleed the
brake system (see page 19-7), and check for leaks at
brake line connections, and retighten if necessary.
Depress the brake pedal several times to set the
self-adjusting brake.
Adjust the parking brake (see page 19-6).
't0.
1 1 .
12.
LOWER RETURN SPRING