Honda Civic Service Manual page 867

Transmission
1 7 .
Cooler Flushing (cont'dl
Make sure the transmission is in the E position.
Fill the transmission with ATF, and run the engine
for 30 seconds or until approximately 0.95 f (1.0 US
qt.,0.8 lmp qt.) is discharged.
Remove the drain hose, and reconnect the cooler
return hose to the transmission (see page l4-192).
Refill the transmission with ATF to the oroDer level
(see page 14-118).
1 8 .
1 9 .
14-18A
TOOL MAINTENANCE
1. Empty and rinse after each use. Fill the can with water
and pressurize the can. Flush the discharge line to
ensure that the unit is clean.
2. lf discharge liquid does not foam, the orifice may be
blocked.
3. To clean, disconnect the plumbing from the tank at
the large coupling nut.
ORIFICE
GRT{G
Remove the in-line filter from the discharge side and
clean if necessary.
The fluid orifice is tocated behind the filter.
Clean it with the pick stored in the bottom of the
t a n k h a n d l e , o r b l o w i t c l e a n w i t h a i r . S e c u r e l v
reassemble all Darts.
FILLER CAP