Honda Civic Service Manual page 675

Transmission
Reassembly (cont'dl
Install the dowel pins.
I n s t a l l t h e t r a n s m i s s i o n h o u s i n g b y a l i g n i n g t h e
groove in the housing with the finger on the stop
f l n g .
GROOVE
2 1 .
Lower the transmission housing with the snap ring
p l i e r s , a n d s e t t h e s n a p r i n g i n t h e g r o o v e o f t h e
countershaft bearing.
TRANSMISSION
HOUSING
13-94
(
23. Check that the snap ring is securely seated in the
groove of the countershaft bearing.
Dimension 6) as instalt6d: 4.6 - 8.3 mm
(0.181 - 0.327 inl
24.
Install the clutch line bracket, transmission hanger
A and back-up light switch ctamp, then tighten the
t r a n s m i s s i o n h o u s i n g a t t a c h i n g b o l t s i n t h e n u m _
bered sequence shown below.
ATTACHING BOLTS
8 x 1.25 mm
TRANSMISSION
HANGER A
27 N m 12.8 kgtm, 20 tbt.trl
BACK.UP LIGHT
SWITCH CLAMP
lar---'o
o
"W