Honda Civic Service Manual page 1279

t
\ b
5.
lf the old quarter glass is to be reinstalled, glue the
upper and lower clips and fastener as shown
N O T E : B e c a r e f u l n o t t o t o u c h t h e q u a r t e r g l a s s
where adhesive will be applied.
>: Clip, fastener locations
A > , 2
B > , 1
2.5 mm
(0.m in.)
Glue the fastener to the body as shown.
>: Fastener location, 1
6 .
)
ALIGNMENT
7.
With a sponge, apply a light coat of glass primer to
the inside face of the quaner glass, as shown, then
lightly wipe it off with gauze or cheesecloth
NOTE:
. Do not apply body primer to the quarter glass,
and do not get body and glass primer sponges
mixed up.
.
Never touch the primed surfaces with your hands.
lf you do, the adhesive may not bond to the quar
ter glass properly, causing a leak after the quar-
ter glass is installed.
.
Keep water, dust, and abrasive materials away
from the Primed surface
t///////7, , aootv a"av crimer here'
MOLDING
15.5 mm 10 mm
10.61 in.l {0.39 in.l
(cont'dl
20-47