Mbs Shift Piece Inspection; Synchro Sleeve, Synchro Hub - Honda Civic Service Manual

Synchro Sleeve,
Synchro Hub
MBS Shift Piece InsPection
1. Measure the width of the MBS shift piece.
Standard;
6.9 - 7.1 mm 10 272 - 0.280 inl
Service Limit: 6.8 mm {0.268 inl
lf the width of the MBS shift piece is less than
service limit, replace the MBS shift piece'
t
I nspection/l nstallati on
' 1 .
lnspect gear teeth on all synchro hubs and synchro
s l e e v e s t o r r o u n d e d o f f c o r n e r s , w h i c h i n d i c a t e
I n s t a l l e a c h s y n c h r o h u b i n i t s m a t i n g s y n c h r o
sleeve, and check for freedom of movement.
NOTE: lf replacement is required, always replace
the synchro sleeve and synchro hub as a set.
SYNCHRO
SLEEVE
When assembling the synchro sleeve and synchro
hub, be sure to match the three sets of longer teeth
(120 degrees apart) on the synchro sleeve with the
three sets of deeper grooves in the synchro Hub
CAUTION: Do not install th€ sYnchro sleeve with
its longsr t€sth in the synchro hub slots bocause ii
will damage ths spring ring.
LONGER TEETH
13-27