Honda Civic Service Manual page 1189

1 0 . l n s t a l l t h e s p e c i a l t o o l o n t o t h e s p r i n g c o v e r , a n d
turn the shaft until the locknut contacts the plate.
Check that the flared end of the spring cover is below
the circlip groove.
Install the circlip into the groove. then remove the
special tool.
NOTE: Check that the circlip is seated in the groove
properly.
1 1 .
12.
CIRCLIP
t . t
SPRING COVER
13. Coat a new piston seal with recommended silicone
grease in the caliper seal set, and install it in the cali-
per.
PISTON BOOT
Replace.
RUBBER GREASE
Apply recommended rubber grease in the caliper
seal set to the sealing lips and inside of a new pis-
ton boot, and install it in the caliper.
Coat the outside of the piston with brake fluid, and
i n s t a l l i t o n t o t h e a d j u s t i n g b o l t w h i l e r o t a t i n g i t
clockwise with the tool.
CAUTION: Avoid damaging the piston and piston
boot.
PISTON SEAL
Replace.
-6l
1 4 .
PISTON
(cont'd)
1 9 - 3 3