Honda Civic Service Manual page 756

From page 14-76
BRN/BLK
BRN/BLK
'96: BLU/RED
,97, '98: GRN/BLK
Measure Powor Supply Cilcuit
Voltage:
1. Turn the ignition switch ON (ll).
2. Measure the voltage between
t e r m i n a l s A 9 a n d A 1 1 a n d
b e t w e e n t e r m i n a l s A 2 2 a n d
424.
RGpair opon or short in the wire
boiween the A11 andlot Ml lor'
minals, the PGM-Fl m.in rel.Y,
end the tu36 box.
Mo.sure D4 IND Voltago:
1. Turn the ignition switch OFF.
2. Connect the A {32P} connector
to the PCM.
3. Connecl a digital multitester
to the B13 and Ag or A22 ter-
minals,
4. Turn the ignition switch ON (ll)
and make sure that the voltage
is available for two seconds.
Chack tor opan in thc wita
bctwoon tha 813 larminal and
th. gauge ar!.mbly. lf wi.c i!
OK, chock for . frulty E indica-
tor light bulb or a l.uhy g.ug.
a.!.mbly printod circuit bolrd.
Chock for loose PCM connoctort.
C h o c k t h o A / T g G a t p o l i t i o n
switch. lI n6ca$sry, substitute a
known-good PCM and rochock.
PCM CONNECTOR A I32PI
Wire side of {emale terminals
1 4- 77