Honda Civic Service Manual page 641

Change Holder Assembly
Clearance Inspection (cont'd)
7. Measure the clearance between the select arm and
t h e 1 0 m m s h i m .
Standard: 0.01 - 0.2 mm (0.0004 - 0.008 in)
lf the clearance is not within the standard, select
and install the appropriate l0 mm shim for the cor-
rect clearance from the chart below.
mm Shim
8 .
SELECT ARM
l0 mm SHIM
Part Number
Thickness
2 4 4 3 5 - 6 8 9 - 0 0 0
0.8 mm (0.031 in)
B
2 4 4 3 6 - 5 8 9 - 0 0 0 1.0 mm (0.039 in)
c
2 4 4 3 7 - 6 8 9 - 0 0 0
1.2 mm (0.047 in)
D 2 4 4 3 8 - 6 8 9 - 0 0 0
1 . 4 m m ( 0 . 0 5 5 i n )
E
2 4 4 3 9 - 6 8 9 - 0 0 0
1 . 6 m m { 0 . 0 6 3 i n )
1 3 - 6 0
I
9. Measure the clearance between the shift arm holder
and the change piece.
Standard;
0.05 - 0.35 (0.fi)2 - 0.014 inl
Service Limit: 0.8 mm (0.03 in)
lf the clearance is more than the service limit. mea_
sure the groove of the change piece.
Standard: 12.05 - 12.15 mm {0.i[7it4 - 0.47txt inl
lf the groove is not within the standard, replace
the change piece with a new one.
lf the groove is within the standard, replace the
shift arm holder with a new one.
v o
SHIFT ARM HOLOER
CHANGE PIECE