Honda Civic Service Manual page 589

Transmission Assembly
Removal(cont'd)
1 7 . R e m o v e t h e t h r e e u p p e r t r a n s m i s s i o n m o u n t i n g
bolts and the lower starter mounting bolt,
STARTER
MOUNTING
BOLT
1 0 x 1 . 2 5 m m
44 N.m (4.5 kgf.m,
33 rbnftl
TRANSMISSION
MOUI{TING EOLTS
1 2 x 1 . 2 5 m m
& N.m (6.5 kgt'm,47 lbl.ftl
18. Remove the rear mount bracket bolts and transmis-
sion mounting bolts.
1 2 x 1 . 2 5 m m
64 N.ft 16.5 kgl.m,47 lbl.ftl
SPECIAL BOLT
Replace.
'll x 1.5 mm
84 N.m (8.5 kgf.m, 61 lbf.ftl
SPECIAL BOLT
Replace.
1 4 x 1 , 5 m l n
84 N.m (8.5 kgl.m, 61
WASI{ER
REAR
MOUNT
BRACKET
rbl.ftt
Pull the transmission away from the engine until it
clears the mainshaft. then lower it on the transmis-
sion jack.
CAUTION: Take caro not to b6nd tho clutch lin€.
1 ( |
Installation
Install the transmission assembly in the reverse order of
removal.
Before installing, check that the two dowel pins are
installed in the clutch housing.
When installing the starter cable, make sure that the
crimped side of the ring terminal is facing out (see
section 23).
Apply grease to the parts as shown, then install the
release fork and release bearing,
N O T E : U s e o n l y S u p e r H i g h T e m p U r e a G r e a s e
(P/N 08798 - 9002).
RELEASE FORK BOLT
1 2 x 1 . 2 5 m m
29 N'm 13.0 kgt,m,
(P/N 08798-90021
22 tbl.ttl
R€LEASE
BEARING
J
RELEASE
FORK
8()07
r a
{PiN 08798-9002)
tP/N 08798-90021
0 . 3 - 0 . 9 g
1 0 . 0 1 - 0 . 0 3 o z l