Honda Civic Service Manual page 970

Drive Pulley/Driven Pulley/Secondary Gear Shaft Speed
Sensors
Replacement
CAUTION: While replacing the speed sensor, be sure not to allow dust and other foreign parliclos to enter into the trans-
mission.
'1.
Disconnect the connectors for the drive pulley, the driven pulley, and the secondary gear shaft speed sensor.
2. Remove the 6 mm bolt from the transmission housing, and remove the drive pulley. the driven pulley, and the sec-
ondary gear shaft speed sensors.
3. Replace the O-rings before reinstalling the drive pulley, the driven pulley, and the secondary gear shaft sp€ed sen-
sors.
6 x 1 . 0 m m
12 N.m (1.2 kgf.m,8.7 lbf.ft)
6 x 1 . 0 m m
12 N.m (1.2 kgt.m,
8.7 tbf.ft)
DRIVEN PULLEY SPEED SENSOB
14-292