Honda Civic Service Manual page 1342

Opener Cables
Opener and Latch
Replacement (cont'dl
Hatch/Fuel lid opener cable l3Dl:
NOTE: Remove the following parts, then pull the carpet
back as necessary (see page 20-66).
.
Rear seat cushion and rear seat back (see page 20-80)
.
Lower anchor bolt from the front seat belt (see page
20 86)
. Side trim {see page 20-60)
. Spare tire lid
. Rear center shelf and rear side shelf {see page 20-60)
. Rear trim panel (see page 20-60)
. Side trim panel (see page 20,60)
>: Clip, cable cushion locations
a > . 9
B > , 1
c > , 1
D > , 5
W#)
FUEL LID LATCH
#,
Route the opener
cable through the
hole in the body.
HATCH/FUEL
LIO
OPENER
Installation is the reverse of the removal procedure.
NOTE:
.
Make sure each opener cable is routed and con-
nected properly.
.
Make sure the hatch and fuel lid open properly.
page 20-112)
20-110
6 x 1 . 0 m m j
9 . 8 N m
{1.0 kgf.m, i
Replacement
NOTE: Take care not to bend the opener cables.
Hood release handle:
NOTE: Remove the kick panel (see pages 20-59, 60.61).
>: Bolt locations, 2
]
I
HOOO OPENER
CABLE
(see page 20-108)
Hood latch:
NOTE: Remove the front bumper (see page 20-94).
>: Eolt locations, 3
I
6 x '1.0 mm
9.8 N.m
11.0 kgf.m,
Installation is the reverse of the removal procedure.
NOTE:
.
Make sure the opener cable is connected properly.
.
M a k e s u r e t h e h o o d o p e n s p r o p e r l y a n d l o c k s
securely.