Honda Civic Service Manual page 1596

Gharging System
Rear Bearing Replacement
1. Pull offthe rear bearing,
.
Make sure the tips of the bearing puller jaws are
thin enough to fit between the bearing and the
slip rings.
.
Do not reuse the bearing.
SLIP RINGS
BEARING PULLER
Use a hand press to install the new bearing. Apply
pressure only on the inner race to avoid damaging
the bearino.
REAB BEARING
23-124
Alternator Reassembly
1 . P u s h t h e b r u s h e s i n , t h e n i n s e r t a p i n o r d r i l l b i t
(about 1.8 mm diameter) to hold them there.
Heat the rear bearing seat in the rear housing as
described on page 23-121. After heating, continue
immediately with assembling before the rear bear-
ing seat cools completely,
Put the rear housing/stator assembly and drive-end
housing/rotor assembly together. tighten the four
through bolts and pull out the pin.
REAR
STATOR ASSEMBLY
After assembling the alternator, turn the pulley by
hand to make sure the rotor rotates smoothlv and
without noise.
BRUSHES
THROUGH BOLT
I
q
%*z
BRUSH AOCESS HOI."E