Igmp Snooping Settings - D-Link DES-3528 - xStack Switch - Stackable Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide

IGMP Snooping Settings

In order to use IGMP Snooping it must first be enabled for the entire Switch under IGMP Global Settings at the top of
the window. You may then fine-tune the settings for each VLAN by clicking the corresponding Edit button. When
enabled for IGMP snooping, the Switch can open or close a port to a specific multicast group member based on IGMP
messages sent from the device to the IGMP host or vice versa. The Switch monitors IGMP messages and discontinues
forwarding multicast packets when there are no longer hosts requesting that they continue.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Settings, as shown below:
The fields that can be configured are described below:
Parameter
IGMP Snooping State
Max Learning Entry Value
(1-1024)
Click the Apply button to accept the changes made for each individual section.
Click the Edit button to configure the IGMP Snooping Parameters Settings.
Click the Modify Router Port
After clicking the Edit button, the following page will appear:
Figure 4-42 IGMP Snooping Settings window
Description
Click the radio buttons to enable or disable the IGMP Snooping state.
Enter the maximum learning entry value.
link to configure the IGMP Snooping Router Port Settings.
Figure 4-43 IGMP Snooping Parameters Settings window
99