Cfm Mp Table; Ethernet Oam; Ethernet Oam Settings - D-Link DES-3528 - xStack Switch - Stackable Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
MA Name
Click the Find button to show the information at the lower half of the window.

CFM MP Table

This window is used to display the CFM MP table on the Switch.
To view this window, click OAM > CFM > CFM MP Table, as shown below:
The fields that can be configured are described below:
Parameter
Port
Level (0-7)
Direction
VID (1-4094)
Click the Find button to show the information at the lower half of the window.

Ethernet OAM

Ethernet OAM (Operations, Administration, and Maintenance), specified in IEEE 802.3ah-2004 clause 57, is a data link
layer protocol which provides network operators the ability to monitor the health of the network and quickly determine
the location of failing links or fault conditions on point-to-point and emulated point-to-point Ethernet link.
OAMPDUs (OAM Protocol Data Units) contain the control and status information used to monitor, and also test and
troubleshoot OAM-enabled links. OAMPDUs traverse a single link being passed between peer OAM entities, and as a
result, are not forwarded by switches. OAM is a slow protocol, i.e. OAMPDU frame transmission rate is limited to a
maximum of 10 frames per second.
The major features of Ethernet OAM are: OAM discovery, link monitoring, remote fault indication and remote loopbacks.

Ethernet OAM Settings

This window is used to configure the ports Ethernet OAM mode. In Active mode the ports can initiate OAM discovery
and start or stop remote loopback. When a port in OAM enabled, any change to the OAM mode will cause the OAM
discovery to be restarted.
To view this window, click OAM > Ethernet OAM > Ethernet OAM Settings, as shown below:
The Maintenance Association Name.
Figure 10-13 CFM MP Table window
Description
Use the drop-down menu to specify the port number.
Specifies the MD Level. If not specified, all levels are shown.
Use the drop-down menu to select Any, Inward or Outward facing MEP.
The VLAN ID of the VLAN.
302