D-Link DES-3528 - xStack Switch - Stackable Reference Manual page 181

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Profile ID
Select ACL Type
802.1Q VLAN
IPv4 DSCP
IPv4 Source IP Mask
IPv4 Destination IP Mask
Figure 7-8 Add ACL Profile window (IPv4 ACL)
Description
Enter a unique identifier number for this profile set. This value can be set from 1 to 14.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or
packet content. This will change the window according to the requirements for the
type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each packet
header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's
header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each frame's
header.
Select Packet Content ACL to instruct the Switch to examine the packet content in
each frame's header.
Selecting this option instructs the Switch to examine the 802.1Q VLAN identifier of
each packet header and use this as the full or partial criterion for forwarding.
Selecting this option instructs the Switch to examine the DiffServ Code part of each
packet header and use this as the, or part of the criterion for forwarding.
Enter an IP address mask for the source IP address.
Enter an IP address mask for the destination IP address.
172