xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
NOTE: If the user wants the change the analyze server ID, he needs to delete the flow sampler and
creates a new one.
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
Analyzer Server ID (1-
4)
Rate (0-65535)
Max Header Size (18-
256)
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries listed.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
sFlow Counter Poller Settings
This window is used to configure the sFlow counter poller parameters. If the user wants the change the analyzer server
ID, he needs to delete the counter poller and create a new one.
The fields that can be configured are described below:
Figure 11-21 sFlow Flow Sampler Settings window
Description
Select a unit to configure.
Use the drop-down menus to specify the list of ports to be configured.
The analyzer server ID specifies the ID of a server analyzer where the packet will be
forwarded.
The sampling rate for packet RX sampling. The configured rate value multiplied by 256
is the actual rate. For example, if the rate is 20, the actual rate 5120. One packet will be
sampled from every 5120 packets. If set to 0, the sampler is disabled. If the rate is not
specified, its default value is 0.
The maximum number of leading bytes in the packet which has been sampled that will
be encapsulated and forwarded to the server. If not specified, the default value is 128.
Figure 11-22 sFlow Counter Poller Settings window
327