Dhcp Relay Interface Settings - D-Link DES-3528 - xStack Switch - Stackable Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
The Implementation of DHCP Relay Agent Information Option 82
The DHCP Relay Option 82 command configures the DHCP relay agent information option 82 setting of the Switch.
The formats for the circuit ID sub-option and the remote ID sub-option are as follows:
NOTE: For the circuit ID sub-option of a standalone switch, the module field is always zero.
Circuit ID sub-option format:
1 Sub-option type
2 Length
3 Circuit ID type
4 Length
5 VLAN: The incoming VLAN ID of DHCP client packet.
6 Module: For a standalone switch, the Module is always 0; for a stackable switch, the Module is the Unit ID.
7 Port: The incoming port number of the DHCP client packet, the port number starts from 1.
Remote ID sub-option format:
1 Sub-option type
2 Length
3 Remote ID type
4 Length
5 MAC address: The Switch's system MAC address.

DHCP Relay Interface Settings

Users can set up a server, by IP address, for relaying DHCP information to the Switch. The user may enter a
previously configured IP interface on the Switch that will be connected directly to the DHCP server using this window.
Properly configured settings will be displayed in the DHCP Relay Interface Table at the bottom of the window, once the
user clicks the Apply button. The user may add up to four server IPs per IP interface on the Switch. Entries may be
deleted by clicking the corresponding Delete button.
Figure 9-2 Circuit ID Sub-option Format
Figure 9-3 Remote ID Sub-option Format
277