Firmware Information Settings - D-Link DES-3528 - xStack Switch - Stackable Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide

Firmware Information Settings

The following screen allows the user to view information about current firmware images stored on the Switch.
To access this table, click System Configuration > Firmware Information Settings
This window holds the following information:
Parameter
ID
Version
Size (Bytes)
Update Time
From
User
Click the corresponding Set Boot button to use this configuration file as the boot up firmware for the Switch. This will
apply upon the next reboot of the Switch.
Click the corresponding Delete button to remove this configuration file from the Switch's memory.
Figure 2 - 2 Firmware Information window
Description
States the image ID number of the firmware in the Switch's memory. The Switch can store
two firmware images for use. Image ID 1 will be the default boot up firmware for the
Switch unless otherwise configured by the user.
States the firmware version.
States the size of the corresponding firmware, in bytes.
States the specific time the firmware version was downloaded to the Switch.
States the IP address of the origin of the firmware. There are five ways firmware may be
downloaded to the Switch.
•
R – If the IP address has this letter attached, it denotes a firmware upgrade
through the serial port RS232.
•
T - If the IP address has this letter attached to it, it denotes a firmware upgrade
through Telnet.
•
S - If the IP address has this letter attached to it, it denotes a firmware upgrade
through the Simple Network Management Protocol (SNMP).
•
W - If the IP address has this letter attached to it, it denotes a firmware upgrade
through the web-based management interface.
•
SSH – If the IP address has these three letters attached, it denotes a firmware
update through SSH.
•
SIM – If the IP address has these letters attached, it denotes a firmware upgrade
through the Single IP Management feature.
States the user who downloaded the firmware. This field may read "Anonymous" or
"Unknown" for users that are unidentified.
8