Dhcp Offer Permit Entry Settings; Access Authentication Control - D-Link DES-3528 - xStack Switch - Stackable Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
Parameter
DHCP Server Screening
Trap Log State
Illegitimate Server Log
Suppress Duration
Unit
From Port/To Port
State
Click the Apply button to accept the changes made for each individual section.

DHCP Offer Permit Entry Settings

Users can add or delete permit entries on this page.
To view this window, click Security > DHCP Server Screening > DHCP Offer Permit Entry Settings, as shown
below:
The fields that can be configured are described below:
Parameter
Server IP Address
Client's MAC Address
Ports
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry based on the information entered.

Access Authentication Control

The TACACS / XTACACS / TACACS+ / RADIUS commands allow users to secure access to the Switch using the
TACACS / XTACACS / TACACS+ / RADIUS protocols. When a user logs in to the Switch or tries to access the
administrator level privilege, he or she is prompted for a password. If TACACS / XTACACS / TACACS+ / RADIUS
authentication is enabled on the Switch, it will contact a TACACS / XTACACS / TACACS+ / RADIUS server to verify
the user. If the user is verified, he or she is granted access to the Switch.
There are currently three versions of the TACACS security protocol, each a separate entity. The Switch's software
supports the following versions of TACACS:
Description
Enable or disable this feature.
Choose an illegal server log suppress duration of 1 minute, 5 minutes, or 30 minutes.
Select the unit to configure.
A consecutive group of ports may be configured starting with the selected port.
Choose Enabled to enable the DHCP server screening or Disabled to disable it. The
default is Disabled.
Figure 8-59 DHCP Offer Permit Entry Settings window
Description
The IP address of the DHCP server to be permitted.
The MAC address of the DHCP client.
The port numbers of the filter DHCP server. Tick the All Ports check box to include all
the ports on this switch for this configuration.
256