Igmp Snooping Static Group Settings - D-Link DES-3528 - xStack Switch - Stackable Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Port List
VID List
Rate Limit
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IGMP Snooping Static Group Settings

Users can view the Switch's IGMP Snooping Group Table. IGMP Snooping allows the Switch to read the Multicast
Group IP address and the corresponding MAC address from IGMP packets that pass through the Switch.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Static
Group Settings, as shown below:
The fields that can be configured are described below:
Parameter
VLAN Name
VID List
Figure 4-45 IGMP Snooping Rate Limit Settings window
Description
Enter the port list used for this configuration.
Enter the VID list used for this configuration.
Enter the IGMP snooping rate limit used. Tick the No Limit check box to ignore the rate limit
for the entered port(s).
Figure 4-46 IGMP Snooping Static Group Settings window
Description
The VLAN name of the multicast group.
The VID list of the multicast group.
102