D-Link DES-3528 - xStack Switch - Stackable Reference Manual page 306

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
Alarm Time (250-1000)
Alarm Reset Time (250-
1000)
Click the Apply button to accept the changes made.
Click the <<Back button to go back to the CFM MEP Settings window.
Click the Remote MEP button to detail information about remote MEP.
Click the Remote MEP button to see the following window.
Xcon CCM - Only the fault alarms whose priority is equal to or higher than "Cross-
connect CCM Received" will be sent.
None - No fault alarm will be sent. This is the default value.
Enter the time period in centisecond to control the fault alarm to be sent if a defect is
reported continuously. The default value is 250.
Enter the time period in centisecond to reset the fault alarm if a defect hasn't been
reported since the last defect report. The default value is 1000.
Figure 10-7 CFM Remote MEP window
297