Table of Contents
Advertisement
M-series and MX-series Devices
Table 132: Configuring Bfd Fields
Field
Comment
Traceoptions
Configuring BGP (NSM Procedure)
254
exchanged after the session is established; it is assumed that the endpoints have another
way to verify connectivity to each other.
To configure BFD:
In the navigation tree select
1.
list.
In the configuration tree, expand
2.
Select
Bfd
.
3.
Add/Modify the parameters under the respective tabs as specified in Table 132 on
4.
page 254.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for Bfd.
Enables you to define tracing operations
that track all routing protocol
functionality in the device. You can
configure the tracing flag, filter, and the
tracing policy.
Border Gateway Protocol (BGP) is used for exchanging routing information between
gateway hosts/internet service providers. The routing information refers to the routing
tables containing information about the list of known devices, the addresses they can
reach, and a cost metric associated with the path to each device so that the best available
route is chosen. The primary function of a BGP speaking system is to exchange network
reachability information with other BGP systems. This feature enables you to configure
BGP peering sessions.
To configure BGP in NSM:
Device Manager > Devices
.
Protocols
Your Action
Enter the comment.
1.
Expand the
Traceoptions
2. Expand the
up the file and flag parameters.
Copyright © 2010, Juniper Networks, Inc.
and select the device from the
Bfd
tree and select
.
tree and set
Traceoptions
Advertisement
Table of Contents
