Loading Drivers With Parameters; Variables And Parameters; Imaging Script Variables - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

2 Change directories to the source and compile the source according to the compilation
instructions provided in the module's Readme.
3 When you have your module compiled for ZENworks, take the generated
(make sure you select the proper module name and not a work
the driver update method
G.5.3 Loading Drivers with Parameters
If there is a module that you want to load during the linuxrc processing time, and if linuxrc does not
recognize that it needs to be loaded or you want to specify the load parameters, you can enter a line
in the
linuxrc.config
You might need to load a LAN driver module with specific parameters. You can do this with a line
like:
insmod="moduleName parm=xxx"
This type of line is most commonly used to load a LAN driver with specific parameters, such as full
duplex or specific speed.
G.6 Variables and Parameters
The following sections describe the variables and parameters used in updating resource files:
Section G.6.1, "Imaging Script Variables," on page 252
Section G.6.2, "Linuxrc Parameters Specified in Settings.txt," on page 253
Section G.6.3, "Image Engine Variables," on page 253
G.6.1 Imaging Script Variables
The following environment variables are used in imaging scripts and must not be modified:

Imaging Script Variables

Table G-1
Variable
ACTIVEPARTITION
CDBOOT
DISABLEZEN
ENABLEZEN
ZENDEVICE
ZENPARTBOOT
The following environment variables can be modified or set in the
252 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
or placing it in the
or file. This file then needs to be updated in the
/info
Definition
Device of the active OS partition.
YES = Booted from a CD.
1 = Disable the ZENworks partition.
1 = Re-enable the ZENworks partition.
Device name of the ZENworks partition.
YES = Booted from ZENworks partition.
file) and install it by using
.ko
file system.
initrd
settings.txt
module file
.ko
file system.
initrd
file: