Using The Image-Safe Data Editor - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

Command
zisview -z field
zisview -s
zisview -h
E.4.3 Using the Image-Safe Data Editor
After booting a device from an imaging boot media, you can enter
maintenance mode prompt to change, clear, or remove information the image-safe data for that
device.
To use , enter any of the following commands at the prompt:
zisedit
zisedit Commands
Table E-3
Command
zisedit
Explanation
Displays information about a specific field or fields. field is one or more
field names separated by a space. field is not case sensitive.
All of the following are valid field names (the corresponding minimum
names that can also be entered on the command line follow each field
name in parenthesis):
JustImaged (J)
ScriptedImage (SC)
LastBaseImage (L)
Zone GUID (T)
Device GUID (ObjectDN)
Device Index (N)
Windows WorkGroup (WorkG)
Windows SID (SI)
WorkstationID (ID)
DHCP (DH)
IP (I)
Gateway (Gateway)
Mask (M)
DNSServerCount (DNSServerC)
DNSServer (DNSServer)
DNSSuffix (DNSSu)
DNSHostName (DNSH)
Creates a script that can be used to generate environment variables that
contain all of the image-safe data fields.
Displays help for zisview
Explanation
Displays a screen showing all of the image-safe data fields. You can add
or change any of the information in the fields.
.
at the imaging
zisedit
Imaging Utilities and Components 201