Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 264

How do I exclude a particular partition from ZENworks Imaging?
How do I prevent ZENworks Third-Party Imaging from restarting in the Auto mode?
Image Explorer help opens only in Firefox on Linux devices
Explanation: When you launch Image Explorer in Linux, then click Help > Contents, the
The ZENworks icon properties page of a managed device that is in private network
displays that the server IP address is not available
Explanation: When you refresh the ZENworks icon of a managed device that is in a private
The third-party Imaging distro and tools are not immediately replicated on the
Satellite
Explanation: The third-party imaging distro and tools are replicated on the Satellite only
264 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
NOTE: The log file is available only until the device is rebooted. To retain the
log file, you must upload it to an FTP server.
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
Action: Before performing any imaging operation, set the following environment
variable in the ZENworks Imaging Maintenance mode:
export Exclude_DEVICE=partition_name
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
Action: A device is automatically rebooted after the ZENworks Third-Party imaging
operation is performed in the Automatic mode. If you want to refer to the
worktodolog.txt
device from rebooting by pressing Ctrl+R at the end the imaging operations.
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
Mozilla* Firefox* browser is opened by default.
Action: If you want to use any other HTML viewer, modify the
ZMGEXP_HELP_BROWSER environment variable to point to the utility of
your choice.
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
network, the properties page displays that the server IP address is not
available. Consequently, the managed device might not be promoted to
Imaging Satellite, or if the managed device is an Imaging Satellite with
ProxyDHCP enabled, the device fails to contact the Primary Server and the
Imaging operations cannot be performed through the device.
Action: On the managed device, edit the
operating_system_drive\windows\system32\drivers\etc\hosts
to add the IP address and the DNS name of the Primary Server to which the
device is registered.
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
during the next ZMD refresh after configuring the Imaging Satellite role.
or
worktododebug.txt
files, you must prevent the
file