Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 178

You can configure the destination disk structure only if the image is restored in one of the following
modes:
Automatic Imaging mode
For more information on the Automatic Imaging mode, see
Control Center for Imaging," on page
Maintenance Imaging mode without configuring the Advanced options.
For more information on how to locally restore an image in the Maintenance Imaging mode,
see Section D.4.4, "Restoring a Locally Stored Image," on page
image to a remote device, see
Network Location," on page
To configure the disk structure of the destination device, do the following before restoring a WIM
image:
1 Manually create an XML file with the filename as
following content:
<ZENWORKS>
<Disk Number="1">
<Partition Number="1" Type="1" Size="14998" Offset="1" Active="1"
FSType="NTFS" Drive="C:" />
<Partition Number="0" Type="2" Size="99378" Offset="14999" Active="0"
FSType="NA" Drive="" />
<Partition Number="2" Type="4" Size="24999" Offset="15000" Active="0"
FSType="NTFS" Drive="D:" />
</Disk>
<Disk Number="2">
<Partition Number="1" Type="1" Size="14998" Offset="1" Active="1"
FSType="NTFS" Drive="C:" />
<Partition Number="0" Type="2" Size="99378" Offset="14999" Active="0"
FSType="NA" Drive="" />
<Partition Number="2" Type="4" Size="24999" Offset="15000" Active="0"
FSType="NTFS" Drive="D:" />
</Disk>
...
</ZENWORKS>
2 Save the
file.
Ensure to follow these guidelines as you work with the XML file:
You can specify only the following disk settings:
Partition Number - The number of partitions that you can create per hard disk is depended upon
number of partitions supported by Windows
Type - Valid values are 1, 2, 4, and 8. Use 1 for Primary partition, 2 for Extended partition, 4 for
Logical partition, and 8 for Linux Swap partition.
Size - Size of the partition. The value must be specified in MB.
Offset - The starting position of the partition
Active - Valid values are 1 and 0 (zero). 1 indicates that the partition is active and 0 indicates
that the partition is not an active partition. A disk can have only one active partition.
FSType - File system type. Valid values are NTFS, FAT12, FAT16, and FAT32.
178 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
Section D.4.5, "Restoring an Image to a Device on a Shared
174.
WIM_image_name-wim.xml
Section 3.1.1, "Using ZENworks
99.
WIM_image_name-wim.xml
created in Step 1 in the same location as the WIM image
173, and how to restore an
with the