Assigning Bundles To Non-Registered Devices - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

4b Click Add as necessary to include the desired devices.
4c In the Shortcut Location section, make sure all check boxes are deselected.
Imaging bundles do not use shortcut locations.
4d Click Next to display the Summary page.
4e Click Finish to complete the assignment.
4f Repeat these steps until all of the desired devices have been assigned to the bundle.
5 To assign the bundle to bundle groups, in the Bundle Groups panel, click Add, in the Select
Groups dialog box, browse for and select the groups, then click OK.
The Bundle Groups the Imaging bundle is assigned to are listed in this panel. Repeat clicking
Add until the Imaging bundle has been assigned to all of the desired Bundle Groups.
When devices assigned to this Bundle Group boot, they are imaged from the image contained in the
Imaging bundle that is assigned to the group.

3.4.4 Assigning Bundles to Non-Registered Devices

1 In ZENworks Control Center, click Configuration in the left pane to display the Configuration
tab, if it's not expanded, click Management Zone Settings.
2 Click Device Management to expand its listing, then select Preboot Services.
3 If necessary, expand the Device Imaging Work Assignment section, then click Add in the
Hardware Rules section to open the Rules Construction dialog box:
Using Imaging 137