Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 126

7 On the Summary tab for the device, click Advanced in the Imaging Work panel.
8 In the Scheduled Work field, select Apply Assigned Imaging Bundle, then click OK.
This sets up a device to do Multicast Image Set bundle work for its effective bundle the next
time it boots.
9 (Conditional) If the multicast session needs to be enabled, continue with
Disabling a Multicast Image Set Bundle" on page
By default, a Multicast Image Set bundle is enabled when you create it.
Assigning Unregistered Devices
1 In ZENworks Control Center, click Configuration in the left pane to display the Configuration
tab, if it's not expanded, click Management Zone Settings.
2 Click Device Management to expand its listing, then select Preboot Services.
3 If necessary, expand the Device Imaging Work Assignment section, then click Add in the
Hardware Rules section to open the Rule Construction dialog box:
For information on the Rule Construction dialog box, see
page 82.
4 In the Bundle to Apply field, browse for and select the desired Multicast Image Set bundle.
5 Fill in remaining the fields to configure the type of device that you want to image in the
multicast session.
6 Click Apply at the bottom of the Preboot Services section to save the non-registered device
settings.
126 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
"Enabling or
127.
"Rule Construction Dialog Box" on