Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 69

The following sections explain how to configure the following ZENworks Imaging Servers:
"Configuring the TFTP Server" on page 69
"Configuring the Proxy DHCP Server" on page 69
"Configuring Novell-pbserv" on page 69
"Configuring Novell-zmgprebootpolicy" on page 70
"Configuring the DHCP Server" on page 70
Configuring the TFTP Server
It is seldom necessary to change the default TFTP server configuration values. If you need to change
them, use the following procedure:
1 Open the following file in an editor:
Windows:
%ZENWORKS_HOME%\conf\preboot\novell-tftp.conf
Linux:
/etc/opt/novell/novell-tftp.conf
2 Edit the configuration settings according to the instructions within the file.
3 Save the changes.
4 On a command line, enter the following:
Windows: In the Services dialog box, right-click Novell TFTP Service, then select Restart.
Linux:
/etc/init.d/novell-tftp restart
Configuring the Proxy DHCP Server
The Proxy DHCP server provides PXE devices with the information that they require to be able to
connect to the Preboot Services system.
Use the following steps to modify the settings of novell-proxydhcp:
1 Open the following file in an editor:
Windows:
%ZENWORKS_HOME%\conf\preboot\novell-proxydhcp.conf
Linux:
/etc/opt/novell/novell-proxydhcp.conf
2 Edit the configuration settings according to the instructions within the file.
3 Save the changes.
4 On a command line, enter the following:
Windows: In the Services dialog box, right-click Novell Proxy DHCP Service, then select
Restart.
Linux:
/etc/init.d/novell-proxydhcp restart
You can set any of the IP address fields to 0.0.0.0 in the configuration utility. The server replaces
these entries with the IP address of the first network adapter installed in the server.
Configuring Novell-pbserv
Novell-pbserv provides imaging services to the devices.
Setting Up Preboot Services and Imaging 69