Performing Zenworks Third-Party Imaging By Using Zenworks Control Center; Setting Up Preboot Services For Zenworks Third-Party Imaging - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

ZENworks 10 Configuration Management supports only the default operations that are
supported by the third-party Imaging tools. To perform advanced imaging operations that are
not directly supported by ZENworks, you can use the third-party Imaging tools later. For more
information on the third-party Imaging tools, see
page 216.
If you want third-party Imaging tools to be replicated on a Satellite, the Satellite must have the
same version of ZENworks 10 Configuration Management installed as that of the Primary
Server.
D.2 Performing ZENworks Third-Party Imaging
by Using ZENworks Control Center
For detailed information, see
page 99.
D.3 Setting Up Preboot Services for ZENworks
Third-Party Imaging
Preboot Services uses PXE to find out if there is imaging work specified for a device and to provide
the device with the files necessary to boot to the third-party imaging environment.
Before you can use Preboot Services with automated Imaging bundles, you need to do the
following:
1 Install ZENworks Configuration Management on your Imaging Server.
For more information on how to install ZENworks Configuration Management, see
the ZENworks
2 Configure the third-party Imaging settings in ZENworks Control Center:
2a Ensure that Microsoft Windows Automated Installation Kit 1.0/1.1/3.0 (WAIK) is
installed on the device running ZENworks Control Center.
You can download WAIK from the
www.microsoft.com/downloads/details.aspx?FamilyID=c7d4bc6d-15f3-4284-9123-
679830d629f2&displaylang=en).
2b (Conditional) If you want to run ZENworks Control Center on a 64-bit device, append the
WAIK_installation_path\Windows AIK\Tools\x86
environment variable.
2c In ZENworks Control Center, click Configuration tab.
2d In the Management Zone Settings panel, click Device Management > Preboot Services >
the Third Party Imaging Settings panel.
168 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
Section 3.1.1, "Using ZENworks Control Center for Imaging," on
Server" in the ZENworks 10 Configuration Management Installation
Section E.9, "TFTP Client for WinPE," on
Microsoft Download Center Web site (http://
to the
"Installing
Guide.
Windows system
Path