Configuring Device Imaging Work Assignments - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

Task
Remove specific
IP addresses from
the Range
Information dialog
box
Edit an IP address
entry
5 Click either Apply or OK to save the changes.
This sets the default device ID method for the Management Zone.

2.5.3 Configuring Device Imaging Work Assignments

You can determine what imaging work is to be performed on a device when it boots, based on a set
of hardware rules. This configuration section lets you specify a particular bundle for each set of
hardware rules. The Custom Hardware Types section allows you to provide specific data for a
Hardware Type hardware rule option.
All rules and custom types configured here are applied globally to all managed devices in the
Management Zone. However, only those devices that exactly match the rule and its custom types
have the assigned bundle applied to them when they boot.
For more information, see
To configure default imaging work assignments for non-registered devices:
1 In ZENworks Control Center, click Configuration in the left pane to display the Configuration
tab, then if it's not expanded, click Management Zone Settings.
2 Click Device Management to expand its listing, then select Preboot Services to display the
configuration sections.
3 Locate and expand the Device Imaging Work Assignment section:
Steps
1. In the IP Address
Configuration panel, click Edit
to open the Range Information
dialog box.
2. In the Used Address Ranges
section, enter a specific IP
address or a range of
addresses in the Remove
field, then click Remove.
1. Select the check boxes for an
IP address entry in the list,
then click Edit to open the
Range Information dialog box.
2. Modify the information as
necessary.
3. Click OK to save the changes.
Section 1.3.4, "Device Imaging Work Assignment," on page
Additional Details
23.
Setting Up Preboot Services and Imaging 79