Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 65

Preboot services and imaging
Hide thumbs Also See for ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010:
Table of Contents

Advertisement

Windows 2000 Advanced DHCP Server : Do the following to set up standard DHCP and Proxy
DHCP on the same Windows 2000 Advanced server:
1 At the command prompt, enter
2 At the netsh prompt, enter
3 At the dhcp server prompt, enter the following:
add optiondef 60 ClassID STRING 0 PXEClient
4 Add the definition type in the DHCP setup menus.
Configuring a WAN/VLAN with Preboot Services and DHCP Running on the Same Server
You can install Configuration Management (which includes Preboot Services) on the same server
where DHCP is installed and running. However, you must do the following to make it work:
Set option tag 60 on the DHCP server so that it can work with novell-proxydhcp. See the steps
in the previous section
On the server, edit the
LocalDHCPFlag = 0
to
LocalDHCPFlag = 1
The file is located at:
Windows:
%ZENWORKS_HOME%\conf\preboot\
Linux:
/etc/opt/novell/
Then restart the service so that the change is recognized by entering the following command on
the server:
Windows: In the Services dialog box, right-click Novell Proxy DHCP Service, then select
Restart.
Linux:
/etc/init.d/novell-proxydhcp restart
IMPORTANT: If the switch is acting as a firewall and limiting the type of traffic on the network,
understand that novell-tftp and novell-zmgprebootpolicy are not firewall or network filter friendly.
You should not attempt to run these services or daemons through a firewall. If users need to pass
preboot work through a firewall, then all Preboot Services work needs to be on the outside and
merely reference a Web service inside the firewall.
Configuring a WAN/VLAN With Preboot Services and DHCP Running on Separate Servers
You can install Configuration Management (which includes Preboot Services) on a separate server
than where DHCP is installed and running. However, you must configure the network equipment so
that it correctly forwards Preboot Services network traffic.
IMPORTANT: If the switch is acting as a firewall and limiting the type of traffic on the network,
understand that novell-tftp and novell-zmgprebootpolicy are not firewall or network filter friendly.
You should not attempt to run these services or daemons through a firewall. If users need to pass
preboot work through a firewall, then all Preboot Services work needs to be on the outside and
merely reference a Web service inside the firewall.
.
netsh
.
dhcp server
("Configuring LAN Environments for Preboot Services" on page
novell-proxydhcp.conf
file and change:
Setting Up Preboot Services and Imaging
64).
65

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Zenworks 10 configuration management sp3

Table of Contents