F Zenworks Imaging Engine Commands; Help Mode; F.1 Help Mode - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

ZENworks Imaging Engine
F
Commands
After booting a device from an imaging boot media, you can use the
maintenance mode prompt or use the Novell
following:
Take an image of the device's hard disks
Restore an image on the device's hard disks
View or manipulate the device's hard disk partitions
View the device's hardware configuration or image-safe data
Display a menu from which you can also perform all of these tasks
Because the ZENworks Imaging Engine is a Linux application, the command syntax is case
sensitive. The overall syntax is:
img mode
where mode is any of the mode commands described in the following sections:
Section F.1, "Help Mode," on page 217
Section F.2, "Automatic (Query for Work) Mode," on page 218
Section F.3, "Make Mode," on page 219
Section F.4, "Restore Mode," on page 225
Section F.5, "Session Mode (Multicast Image Set)," on page 230
Section F.6, "Partition Operations Mode," on page 233
Section F.7, "ZENworks Partition Management Mode," on page 236
Section F.8, "Dump Mode," on page 237
Section F.9, "Information Mode," on page 238
Each mode command can be abbreviated to the first letter of its name. For example,
be abbreviated as
img -d
To access the ZENworks Imaging Engine menu and perform all of these tasks, enter
The ZENworks Imaging Engine menu is a character-based display where you can access the menu
items by using the mouse or by using the Alt key with the highlighted menu option letters.
Exiting the ZENworks Imaging Engine menu returns you to the imaging maintenance mode prompt.

F.1 Help Mode

Use the mode command to get information about the
-help
documentation available.
®
ZENworks
.
command at the imaging
img
®
Imaging Engine menu to do any of the
command if you don't have this
img
ZENworks Imaging Engine Commands
F
can
img -dump
by itself.
img
217