Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 221

7 Click Next to make the image.
The ZENworks Imaging Engine Menu displays a progress bar while making image.
8 If the imaging process was successful, click OK in the Information dialog box, then click Close
to return to a blank ZENworks Imaging Engine Menu display.
If the imaging process was unsuccessful, determine and resolve the issue, then repeat these
steps.
Using the Imaging Maintenance Mode Prompt to Make an Image Locally
Using the imaging maintenance mode prompt, the following example explains the syntax and
available parameters that you can use with the "make locally" (
img -make -local local_filepath/filename.zmg [-part=partition_number]
[-comp=comp_level] [-exclude=partition_number] [-include=partition_number]
where the [...] brackets indicate optional commands.
You can abbreviate
-make -local
You can also abbreviate
-exclude
For more information, see:
"Command Details" on page 221
"Examples" on page 222
Command Details
Make Local Commands and Parameters
Table F-2
Parameter
local_filepath/filename.zmg
-part=partition_number
or
-P=partition_number
-comp=comp_level
as: ,
-m -local
as and
-x -include
Specifies
The image filename, including the
sensitive), and any local path. However, the directories in the path must
exist.
If the file already exists, an error is given. You must use a different
filename or delete the existing image file in order to use that filename.
The partition number of the local partition for where to store the image. It
must be a primary partition. This partition is excluded from the image that
is created.
Be sure to specify an existing partition that has enough space to store the
image file.
Available partitions can be displayed using
If you omit the partition number from this parameter, or do not use this
parameter, the image is stored in volatile RAM.
comp_level is the amount of compression used when creating the image.
Specify any number from 0-9. 0 means no compression. 1 is the same as
Optimize for Speed and is used by default if you do not specify this
parameter. 6 is similar to Balanced. 9 is the same as Optimize for Space,
which provides the slowest performance.
) mode command:
-makel
, or .
-makel -ml
as .
-I
.zmg extension (which is case
img -dump
ZENworks Imaging Engine Commands 221
.