Zenworks Partition Management Mode; Using The Zenworks Imaging Engine Menu To Manage A Partition; Using The Imaging Maintenance Mode Prompt To Manage A Partition - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

Example
img -pa 1
F.7 ZENworks Partition Management Mode
Use the
-zenpart
To use the Help mode:
Section F.7.1, "Using the ZENworks Imaging Engine Menu to Manage a Partition," on
page 236
Section F.7.2, "Using the Imaging Maintenance Mode Prompt to Manage a Partition," on
page 236
F.7.1 Using the ZENworks Imaging Engine Menu to Manage a
Partition
1 To display the ZENworks Imaging Engine menu, enter:
img
2 Click Partitioning, then click one of the following:
Disable ZEN Partition: Disables the ZENworks partition.
Enable ZEN Partition: Enables the ZENworks partition.
Remove ZEN Partition: Removes the ZENworks partition.
IMPORTANT: If you remove an installed ZENworks partition, you must immediately restore
a base image with a valid non-grub MBR (Master Boot Record). If you do not, the device
cannot boot properly.
3 Click Imaging > Exit to display the imaging maintenance mode prompt.
4 At the prompt, enter
F.7.2 Using the Imaging Maintenance Mode Prompt to Manage
a Partition
Using the imaging maintenance mode prompt, the following example explains the syntax and
available parameters that you can use with the various ZENworks partition management mode
commands:
img -zenpart operation
where operation is to disable, enable, or remove a ZENworks partition.
To manage a ZENworks partition:
1 From the imaging maintenance mode prompt, enter one of the following:
img -zenpart -disable
img -zenpart -enable
img -zenpart -remove
236 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
or
img -pa1
mode command to enable, disable, or remove the installed ZENworks partition.
to make this change effective.
grub.s
Explanation
Creates a active partition in slot 1.