Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 205

Parameter
netmask
gateway
nameserver
domain
PROXYADDR
Specifies
Specifies the subnet mask to be used by the device, if the device is
using a static IP address.
Example: netmask=255.255.252.0
If DHCP is being used, leave this parameter commented out.
Specifies the IP address of the gateway (router) to be used by the
device, if the device is using a static IP address.
Example: gateway=123.45.67.254
If DHCP is being used, leave this parameter commented out.
Specifies the list of DNS name servers, by IP address, to use for
resolving DNS domain names used on this device. Use a space to
separate entries.
Example: nameserver=123.45.6.7 123.45.6.9
If DHCP is being used, leave this parameter commented out.
Specifies the list of DNS domain suffixes to be used to identify
connections used by this device. Use a space to separate entries. For
example:
domain=example.novell.com example.xyz.org
If DHCP is being used, leave this parameter commented out.
Specifies the IP address or full DNS name of the imaging (proxy) server
to connect to when you boot a device from the imaging boot media in
auto-imaging mode.
Examples:
PROXYADDR=123.45.67.89
PROXYADDR=imaging.xyz.com
This parameter is used to set the PROXYADDR environment variable
when the device is booted from an imaging boot media (other than
PXE). The ZENworks Imaging Engine then reads this variable to
determine which server to contact if it is running in automatic mode.
Whether it is running in automatic or manual mode, the ZENworks
Imaging Engine attempts to log the imaging results to the server
specified in this variable.
IMPORTANT: This parameter is set automatically when booting PXE
and normally should not be modified in the copy of
that is used by PXE:
Windows:
%ZENWORKS_HOME%\share\tftp\boot\
Linux:
/srv/tftp/boot/
settings.txt
Imaging Utilities and Components 205