A Preboot Actions; Action - Imaging Script - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

Preboot Actions
A
The Actions panel displays the action sets available for the bundle. Depending on the bundle type,
the possible action sets are Install, Launch, Verify, Uninstall, Terminate, and Preboot. For example,
if you select a Windows bundle, five actions sets are available. If you select an Imaging bundle,
Preboot is the only action set available.
You can add an action to any of the available action sets. When you do so, that action is performed
whenever the action set is applicable. For example, when you add an action to the Install action set,
that action is performed whenever the bundle is installed.
The following sections contain information about the actions you can configure for the Preboot
action set. For more information about the actions you can configure for the Install, Launch, Verify,
and Terminate action sets, see "Actions" in the
Distribution Reference.
Section A.1, "Action - Imaging Script," on page 147
Section A.2, "Action - Linked Application Bundle," on page 148
Section A.3, "Action - Multicast Image Set," on page 149
Section A.4, "Action - ZENworks Image," on page 151
Section A.5, "Action - Third Party Image," on page 152
A.1 Action - Imaging Script
Depending on which dialog box you accessed, you can either add a new Imaging Script action to the
current bundle's Preboot actions, or edit an existing Imaging Script.
An Imaging Script bundle can contain any ZENworks script (containing the general shell and
ZENworks Imaging Engine
prompt.
ZENworks 10 Configuration Management Software
commands) that you can run from the imaging maintenance mode
A
Preboot Actions 147