Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 267

novell-pbserv crashes during multicast imaging to 120 or more devices
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
Possible Cause: The OpenSSL library, which is used by the ZENworks Imaging server to
communicate over SSL with Tomcat on ZENworks Control Center, crashes.
Action: Do the following on the ZENworks Imaging server:
1 Edit the
2 Restart the Novell ZENworks Preboot Service.
You might encounter an error message prompting you to restart Windows
installation when the device boots up after the restoration of the ZENworks or WIM
image on a Windows 7 or Windows 2008 R2 device
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
Explanation: After restoring a ZENworks or WIM image of a Windows 7 or Windows 2008
R2 managed device that was taken by running SysPrep, the device boots up
and you are prompted to configure the language, product key, and license
agreement. After you configure them, the Windows service starts but the
following error message is displayed:
Windows could not complete the installation. To install
windows on this computer, restart the installation.
Action: Ignore the error message.
If you restore an image of Windows Vista, Windows 7, or Windows 2008 R2 on a bare
machine that has a ZENworks partition, the machine fails to boot the second time
after the image restoration
Source: ZENworks 10 Configuration Management; Preboot Services and Imaging.
Explanation: If you restore an image of Windows Vista, Windows 7, or Windows 2008 R2
on a bare machine that has a ZENworks partition, the machine successfully
boots for the first time after the image has been restored but it fails to boot the
second time.
b. In the Windows Services window, stop the Novell ZENworks
Agent Service and change the service's Startup Type to Manual.
c. Reboot the device.
2. Take the image of the device that has the ZDM 7.x agent and the
ZENworks Adaptive Agent with Asset Management installed.
3. After restoring the image on a non-registered device, do the
following on the device whose image you have taken:
a. In the Windows Services window, change the Startup Type of
Novell ZENworks Agent Service to Automatic, and start the
service.
b. Reboot the device.
%zenworks_home%\conf\preboot\novell-zenimgweb.conf
file to uncomment the following entry, which is beneath the line "
HTTP if HTTPS is not available
CLEARTEXT=FALSE
":
Troubleshooting Preboot Services and Imaging 267
#Allow