Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 226

Path to Image Archive: Click Browse to select the image file, or specify its full path and
filename, including the
File Set: The number of the image file set to be restored. Valid values are 1 through 10. File set
1 defaults. For information on file sets, see
page 155.
Options: Specify any advanced options. For more information, see
5 Click Next to restore the image.
The ZENworks Imaging Engine Menu displays a progress bar while restoring image.
6 If the imaging process was successful, click OK in the Information dialog box, then click Close
to return to a blank ZENworks Imaging Engine Menu display.
If the imaging process was unsuccessful, determine and resolve the issue, then repeat these
steps.
Using the Imaging Maintenance Mode Prompt to Restore an Image Locally
Using the imaging maintenance mode prompt, the following example explains the syntax and
available parameters that you can use with the "restore from local" (
img -restore -local local_filepath/filename.zmg [-part=partition_number]
[-s=file_set] [-ap=advanced_options]
where the [...] brackets indicate optional commands.
You can abbreviate
For more information, see:
"Command Details" on page 226
"Examples" on page 227
Command Details
Restore Local Commands and Parameters
Table F-6
Parameter
-restorel
[-part=partition_number]
local_filepath/
filename.zmg
-s=fileset
226 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
filename extension.
.zmg
as:
-restore -local -r -local
Specifies
The partition number (as displayed by
retrieve the image from. It must be a primary partition. This partition is not
changed by the imaging operation.
The filename of the image to retrieve, including the
sensitive) and the complete path from the root of the local partition.
The number of the image file set to be restored. Valid values are 1 through 10.
For information on creating file sets of an image, see
Installing, and Restoring Standard Images," on page
If you omit this parameter, file set 1 is used.
Appendix B, "File Sets and Image Numbers," on
Table F-6 on page
-restorel
, , or
-restorel -rl
) of the local partition to
img dump
226.
) mode command:
.
.zmg extension (case-
Section 1.5.2, "Creating,
35.